A magnetic drill’s capacity is the largest size of hole and thickness of steel that it can slice through, always clearly presented on the spec sheet in millimeters, such as 32mm, 50mm, 100mm, along with the wattage of the motor and magnet hold force. While a larger number means a…

As a carbide tip single point tool Dubai traders believe nowadays features a tungsten carbide tip attached through brazing on the shank, making the tool efficient in cutting metal with fast speed. In 2026, the major innovations are in coatings and cutting geometries, not in the material itself. Each producer…

When it comes to steel fabrication, if the plate thickness exceeds 6mm, or the hole size is bigger than what a hand drill can do, magnetic drills pull ahead; their magnetic base has the strength to hold the steel surface with approximately 800 to 3,600 pounds, depending on the model.…

Mounted points are small abrasive forms that are made up of a metal shank. They help grind, polish, and deburr surfaces that cannot be reached using conventional wheels. Mounted points have a wide range of designs and sizes, and they serve various purposes depending on the material being worked on. …

Across UAE industries, carbide tipped single point tools are being used instead of HSS tools because tungsten carbide has hardness ratings of 89 to 95 HRA while HSS has hardness ratings of 62 to 68 HRC, and it hardly gets softer under conditions of heat, losing only about 10% of…

There is no one single winner. Stainless steel has the following: takes heavy load and does well in corrosive environments; brass is good for conductivity and easy machining. Another issue is that stainless steel has a higher tensile strength, around 505-515 MPa, compared to brass, whose tensile strength ranges between…

Key takeaways A flap wheel usually lasts somewhere between 20 and 80 hours of active grinding, though the honest answer is “it depends on what you’re doing with it.” A wheel used for light deburring on aluminum will outlast one running hard against cast iron all day, sometimes by three…